remote control hovercraft radio control hobby model

Product description

All Lander Remote Control Turbo Hovercraft Kit:

It is fully assembled hovercraft with all necessary hardware to install radio receiver and servos and to install the engine.

Whole hovercraft assembly is made of:

	Top of the body,
	Bottom part of the craft together with skirt and pressurized tube,
	Duct with the air catching system,
	Two rudders,
	Rudders connecting rod assembly,
	Steering push-rod assembly;
	Carburettor slide valve push-rod assembly;
	Fuel tank and fittings,
	Fuel pipe,
	Radio compartment cover,
	Body glow plug terminal assembly;

Whole kit is coming with:

	Hovercraft Muffler and silicone tube and cable tie;
	Right and left engine mounts for optional MVVS 40 engine or blank once to suite the other engines;
	Two bladed propeller;
	Spring for the air supply tube;
	Stainless steel hose clamp for the air supply tube;
	2 x Length 12 mm allen hex bolt to bolt muffler to the engine;
	2 x Length 40 mm self tapers screws for right engine mount;
	4 x Length 16 mm allen hex bolts to install engine mounts to the engine;
	2 x Length 30 mm allen hex bolts for left engine mount;
	6 x M3 lock nuts;
	2 x 3mm nylon washers;
	Front Duct Cover Mesh;
	1 x nylon Front Duct Cover Mesh holder;
	2 x Length 11mm self tapers screws for Front Duct Cover Mesh installation;
	Hovercraft kit box.

Putting the hovercraft together with the engine and radio will take the average modeller only around two hours as all the hard work has been done at the factory.

Home

All Lander Remote Control Turbo Hovercraft

125 Westall Rd , South Clayton, VIC 3169, Australia

Tel: +61 3 9548 1025 Fax: +61 3 9548 3985

Host of the site:Angelo Goulianos agoulian@bigpond.net.au
Copyright © 2000 by All Lander Remote Control Turbo Hovercraft. All rights reserved. Revised : 05 Nov 2000 17:23:43 + 1000
Revised: 09 Oct 2003 04:29:47 -0000 .